How to properly assemble the DMD system?

How to properly assemble the DMD system?

  1. Use the DMD system assembly manual for all installation and disassembly instructions.

  2. The DMD system is designed for stationary installation only, at locations approved by the APSTEC technical team.

  3. Assembly must be performed only by trained personnel, the APSTEC technical team, or an authorized organization.

  4. Do not move, relocate, or operate the DMD system at any site not approved by APSTEC. If an end user does so, APSTEC is not responsible for any operational or performance issues.

  5. End users must not open the system casing.

    • Related Articles

    • How to properly store the DMD system?

      The DMD system must be stored in facilities under the same conditions as described in the article on transportation. Keep the DMD system in a dry place. Do not turn over the boxes containing the system. Boxes from the same system may be stacked, but ...

    • What Safety Rules Should You Follow When Using the DMD System?

      Read and keep these instructions. Improper use or failure to follow the safety guidelines described below may result in injury, equipment malfunction, or breakdown. Connect the device only to a power outlet equipped with proper grounding. Make sure ...

    • How to Operate the DMD System?

      1. System initialization and Operating Modes The user can perform several actions to operate the DMD system: Power On — Turns on the system from a powered-off state. After switching on, the system automatically enters the Initialization phase. ...

    • How to safely transport the DMD system?

      The DMD system can be transported by any means of transport if the following conditions are met: Transport the system only in the manufacturer’s original packaging. The system must be kept in a horizontal position and handled according to all ...

    • How to Switch Off the DMD System Correctly?

      The DMD system should be switched off in the following way: