HSS.2A REPAIR,RECYCLING AND WARRANTY

1. Repairs must be carried out only by authorized specialists from Apstec Systems. For repair contacts, refer to the “Contact Information” section.

2. Disposal and recycling of the HSS system must follow local regulations for electronic and industrial equipment. The process should comply with procedures accepted in the user’s organization.

3. The warranty terms are defined in your purchase documents. Warranty service is normally provided through authorized distributors. To confirm warranty coverage, contact the organization where the device was purchased.

The user is responsible for properly handling and maintaining the HSS system and any additional equipment provided with it. The system must be operated only as described in the official documentation.

Apstec Systems is not responsible for any damage resulting from incorrect or negligent use, or from ignoring the recommended operating conditions.

The user must also monitor the system’s performance, record any issues, and report them to Apstec Technical Support.

• Related Articles

• HSS.2A DIMENSIONS

  External dimensions - 2245 mm х 1341 mm х 580 mm Required minimal space for HSS installation - 1.8 m x 1.5 m Passage width - 1.2 m The Inspection zone of HSS system

• HSS.2A STORAGE

  The HSS must be stored in indoor facilities that meet the conditions specified in Table. Parameter Value Air temperature -40°C to +55°С Humidity 5% to 90%, non-condensing Keep the HSS in a dry place. Do not turn the boxes over. Do not stack the ...

• HSS.2A SAFETY WARNINGS

  Please read and keep these instructions. Failure to follow them may result in injury, malfunction, or damage to the device. Connect the device only to a properly grounded power outlet. Do not remove the grounding pin from the power plug. Make sure ...

• HSS.2A GENERAL INFORMATION

  Human Security Scanner (HSS) is a people-screening solution that uses microwave and passive magnetometry technologies to detect threats. It can identify explosives, narcotics, firearms, and metals carried on the body or in backpacks and handbags. ...

• HSS.2A SPECIFICATION

  PARAMETER VALUE Voltage 100 - 240 VAC, 50 - 60 Hz Rated input (AC) power 150 W Peak input (AC) power 250 W Net weight of HSS.2A system 90 kg IP rating IP54 External dimensions (See Fig. 1) 2245 mm х 1341 mm х 580 mm Required minimal space for HSS ...