How Should the DMD System Be Packaged and Labeled?
The DMD system must be transported and stored using three specially designed boxes that ensure safe handling. Using any alternative packaging is strictly prohibited, as it may cause damage during transport. When packing the system in accordance, all collisions and impacts to the device and its components must be avoided.
Shipping labels must correspond to the design documentation and include the following markings: UP, FRAGILE, KEEP DRY, DO NOT TURN OVER, DO NOT STACK.
Related Articles
How to properly store the DMD system?
The DMD system must be stored in facilities under the same conditions as described in the article on transportation. Keep the DMD system in a dry place. Do not turn over the boxes containing the system. Boxes from the same system may be stacked, but ...
How to properly assemble the DMD system?
Use the DMD system assembly manual for all installation and disassembly instructions. The DMD system is designed for stationary installation only, at locations approved by the APSTEC technical team. Assembly must be performed only by trained ...
How to Operate the DMD System?
1. System initialization and Operating Modes The user can perform several actions to operate the DMD system: Power On — Turns on the system from a powered-off state. After switching on, the system automatically enters the Initialization phase. ...
How to safely transport the DMD system?
The DMD system can be transported by any means of transport if the following conditions are met: Transport the system only in the manufacturer’s original packaging. The system must be kept in a horizontal position and handled according to all ...
How to Switch Off the DMD System Correctly?
The DMD system should be switched off in the following way: