How Should the DMD System Be Repaired, Recycled, and Maintained?
The DMD system must be repaired only by authorized Apstec Systems personnel. Any unauthorized repair attempts may cause damage and void the warranty.
When the system reaches the end of its service life, it must be recycled in compliance with regulations for electrical and electronic equipment. This process should follow the procedures established within the user’s organization.
The warranty for the DMD system is specified in the purchase documents. Warranty service is usually provided through authorized Apstec distributors. To confirm the applicable warranty terms, please contact the organization from which you purchased the equipment.
The user is responsible for the proper use and protection of the DMD system and all related equipment. The system must be operated strictly according to the instructions provided.
Apstec Systems is not responsible for any damage resulting from misuse, negligence, or failure to follow the specified operating conditions.
The user must also monitor the system’s performance and condition, record any issues, and report them to Apstec Systems’ technical support team.
Related Articles
How to properly store the DMD system?
The DMD system must be stored in facilities under the same conditions as described in the article on transportation. Keep the DMD system in a dry place. Do not turn over the boxes containing the system. Boxes from the same system may be stacked, but ...How to properly assemble the DMD system?
Use the DMD system assembly manual for all installation and disassembly instructions. The DMD system is designed for stationary installation only, at locations approved by the APSTEC technical team. Assembly must be performed only by trained ...How to Operate the DMD System?
1. System initialization and Operating Modes The user can perform several actions to operate the DMD system: Power On — Turns on the system from a powered-off state. After switching on, the system automatically enters the Initialization phase. ...How to safely transport the DMD system?
The DMD system can be transported by any means of transport if the following conditions are met: Transport the system only in the manufacturer’s original packaging. The system must be kept in a horizontal position and handled according to all ...How to Switch Off the DMD System Correctly?
The DMD system should be switched off in the following way: