HSS.2A SAFETY WARNINGS

Please read and keep these instructions. Failure to follow them may result in injury, malfunction, or damage to the device.

1. Connect the device only to a properly grounded power outlet.
   
2. Do not remove the grounding pin from the power plug.
   
3. Make sure the system is fully assembled and correctly connected before switching it on.
   
4. The use of a residual current device (RCD) with a 30mA rating is recommended for added safety.
   
5. Use the system only as intended—improper use may compromise safety and performance.
   
6. Follow the assembly and disassembly instructions carefully.Disconnect RF cables from both sides of the arch before dismantling.
   
7. Maintain the temperature and humidity conditions specified in the manual.
   
8. Avoid directing bright light at the system’s cameras.
   
9. Inspect the device casing before turning it on.
   
10. Do not use it if the casing is damaged.Set up the system only on a flat, level surface.
    
11. Ensure a qualified professional verifies grounding at the installation site.
    
12. If the system is moved, check the grounding again at the new location.
    
13. Do not attempt to repair the system yourself—contact technical support.
    
14. If the outer casing is damaged, immediately disconnect power.
    
15. The casing provides protection against dust and moisture.
    

• Related Articles

• HSS.2A GENERAL INFORMATION

  Human Security Scanner (HSS) is a people-screening solution that uses microwave and passive magnetometry technologies to detect threats. It can identify explosives, narcotics, firearms, and metals carried on the body or in backpacks and handbags. ...

• What Should You Know About the DMD System?

  DMD is a walk-through metal detector developed by APSTEC. It is designed for stand-off screening of pedestrian traffic to detect metal objects concealed under clothing or in personal belongings, helping to identify potential threats before entry into ...

• What Safety Rules Should You Follow When Using the DMD System?

  Read and keep these instructions. Improper use or failure to follow the safety guidelines described below may result in injury, equipment malfunction, or breakdown. Connect the device only to a power outlet equipped with proper grounding. Make sure ...

• HSS.2A DIMENSIONS

  External dimensions - 2245 mm х 1341 mm х 580 mm Required minimal space for HSS installation - 1.8 m x 1.5 m Passage width - 1.2 m The Inspection zone of HSS system

• HSS.2A STORAGE

  The HSS must be stored in indoor facilities that meet the conditions specified in Table. Parameter Value Air temperature -40°C to +55°С Humidity 5% to 90%, non-condensing Keep the HSS in a dry place. Do not turn the boxes over. Do not stack the ...