HSS.2A SPECIFICATION

HSS.2A SPECIFICATION

PARAMETER 

VALUE
 
Voltage
100 - 240 VAC, 50 - 60 Hz 
Rated input (AC) power 
150 W
Peak input (AC) power
250 W 
Net weight of HSS.2A system 
90 kg 
IP rating
IP54 
External dimensions (See Fig. 1) 
2245 mm х 1341 mm х 580 mm 
Required minimal space for HSS installation
1.8 m x 1.5 m
Passage width 
1.2 m 
Hours of operation 
Continuous 24/7 
Speed of analysis 
Real-time
Automatic decision-making
Yes
  1.  Due to our continuing program of research and development, the specification herein is subject to change without notice.
  1. Specifications may differ from country to country.
APSTEC Systems reserves the right to make any changes to the design, construction, and operating software of the HSS system. These changes may not be explicitly mentioned in this document but will not affect any technical characteristics and compliance of the system itself.

    • Related Articles

    • HSS.2A GENERAL INFORMATION

      Human Security Scanner (HSS) is a people-screening solution that uses microwave and passive magnetometry technologies to detect threats. It can identify explosives, narcotics, firearms, and metals carried on the body or in backpacks and handbags. ...

    • HSS.2A DIMENSIONS

      External dimensions - 2245 mm х 1341 mm х 580 mm Required minimal space for HSS installation - 1.8 m x 1.5 m Passage width - 1.2 m The Inspection zone of HSS system

    • HSS.2A STORAGE

      The HSS must be stored in indoor facilities that meet the conditions specified in Table. Parameter Value Air temperature -40°C to +55°С Humidity 5% to 90%, non-condensing Keep the HSS in a dry place. Do not turn the boxes over. Do not stack the ...

    • HSS.2A TRANSPORTATION

      The HSS can be transported using any type of vehicle, as long as the following conditions are met: The system must be transported only in the original packaging provided by the manufacturer. The system must be kept in a horizontal position, and all ...

    • HSS.2A ASSEMBLING

      The HSS is intended for stationary installation and must be placed at a location approved by the APSTEC technical team. Installation should be carried out only by trained personnel, either from the APSTEC technical team or an authorised organisation, ...