HSS.2A NETWORK AND USER DEVICE CONNECTION

HSS.2A NETWORK AND USER DEVICE CONNECTION

The HSS system can be connected via Wi-Fi or Ethernet. To access the system, use the authorisation card with QR code, login, and password.




Wi-Fi connection (local):

  • Connect to the HSS Wi-Fi network (usually 10.0.0.1)

  • Use a tablet, laptop, or PC

  • Open a browser and enter: http://10.0.0.1

  • Enter login and password from the card


HSS external standalone connection



Ethernet connection (local):

  • Connect the HSS directly to a PC using an Ethernet cable

  • In the browser, go to: http://10.0.0.1

  • Log in using the authorisation card


HSS ethernet port





Connection through local network (DHCP):

  • Connect the HSS and PC to the same network with DHCP

  • Use the IP address assigned to the HSS

  • Open the browser and log in using the card 


 HSS external connection to client infrastructure without router 




Remote connection through Wi-Fi router:

  1. Connect both the HSS and the user device to the same Wi-Fi network

  • Make sure you know which Wi-Fi you are using (HSS or router)

  • Remote support is possible only in this setup


HSS external connection with remote support with router 



Additional notes:

  • Ethernet cable color may affect remote support (ask Apstec)

  • If the card is lost, contact Apstec support


 The QR code located at the Authorization card (left) and under the hatch (right) 


    • Related Articles

    • HSS.2A ALARM MONITOR CLIENT- GENERAL OVERVIEW

      Alarm Monitor Client (AMC) is software used to receive alarm signals from the HSS system. It can be installed on a PC (Desktop AMC) or a mobile device (Mobile AMC). Main Functions: Displays a photo of the person or object that triggered the alarm. ...

    • HSS.2A SERVICE INTERFACE

      Service interface This section describes how to use the different tabs in the service interface. Only users with administrator rights have access. The layout and options may vary depending on the version of the system. The interface is used to ...

    • HSS.2A NETWORK AND TECHNICAL REQUIREMENTS

      Operator’s PC Ethernet port for internet connection Power socket for the PC Network connection The HSS can connect to the operator’s PC in the following ways: Direct Ethernet cable (DHCP must be enabled) Built-in Wi-Fi module on the HSS Customer’s ...

    • HSS.2A REPAIR,RECYCLING AND WARRANTY

      1. Repairs must be carried out only by authorized specialists from Apstec Systems. For repair contacts, refer to the “Contact Information” section. 2. Disposal and recycling of the HSS system must follow local regulations for electronic and ...

    • HSS.2A STATUS CHANGE AND OPERATOR ACTIONS

      The HSS does not make decisions. It alerts the operator to possible threats. All further actions must follow the organization's internal security procedures. Message Status description Operator’s Action Connected Green. System is operating normally ...